Barco MGP D5 Projector User Manual


 
User Guide USING THE PROJECTOR
MGP D5 23
USING THE PROJECTOR
After setting-up, switch on all equipment.
To switch the projector on, firmly press the POWER button on the
keypad or the remote control. The STATUS indicator will turn from
yellow to green when the unit is switched on.
If the STATUS indicator is flashing yellow, please wait until it turns
permanent yellow.
When only one source is connected, the projector will auto-
detect that source. If more sources are connected, the projector
will search for the next active source according to the following
list, provided that SOURCE SCAN is set to ON in the SET UP sub
menu (see description of menu system):
•VGA 1
•VGA 2
•DVI-D
Component
•S-Video
Composite Video
Select between the sources by pressing the SOURCE buttons on
the keypad or the remote control. Only sources that are active
will be displayed.
If no source is active, searching messages will appear on the
screen.
If no source is active for a long time, the projector will go in
standby mode if DPMS (power save) is set to ON in the SET UP
sub menu. The STATUS indicator will turn from green to flashing
yellow, then yellow. The projector will be switched back on if at
least one source is (re)activated. The power-down function can
be disabled in the menu. See DPMS in the SET UP sub menu.
To switch the projector off, firmly press the POWER button on the
keypad or the remote control twice (to confirm that you really