Filter
Top Products
Connect the included power adapter into an available power outlet. Attach the barrel
plug into the power jack of the AP. You should see the power LED light turn on, the
system light blink a few times, and then the system, LAN, USB 1, USB 2, and
Bluetooth lights will blink repeatedly as the AP initiates itself. The initiation process
will take approximately 20 seconds.
TIP: The system LED blinks once per second indicating that the AP is functioning
properly. The system light will blink three times per second if the IP address has not
been set. If any lights other than the power light remain solid, there is some problem
with the unit. Consult the troubleshooting guide at the end of your User Manual.
HARDWARE INSTALLATION
12
P74181_F8T030_man.qxd 1/10/03 5:34 PM Page 12