Filter
Top Products
18
Manually Configuring your Modem-Router
Manually Configuring your Modem-Router
19
section
2
1
3
4
5
6
7
unless you need to change it. After any changes are made you must
click on “Save Settings” to apply them.
Note: If you check “Enabled” and specify an IP address of 0.0.0.0, any
host can manage the Modem-Router.
For remote management via WAN IP address you need to connect
using port 8080. Simply enter WAN IP address followed by :8080 in the
address field of your web browser, for example, 123.123.123.123:8080.
This applies unless you change the port setting, in which case you
need to substitute the 8080 for whatever port you assign.
DNS
Domain Name Servers
are used to map a
domain name (e.g.,
www.somesite.com) to
the equivalent numerical
IP address (e.g.,
64.147.25.20). Your ISP
should provide the IP
address of one or more
Domain Name Servers.
If your ISP requires you
to manually specify the
addresses, enter them
on this page.
WAN
Specify the WAN (Wide Area Network) connection parameters provided
by your Internet Service Provider (ISP).
ATM PVC
The Modem-Router uses
ATM (Asynchronous
Transfer Mode) as its
WAN interface. Click on
each ATM VC for WAN
configuration.
See the table below
for a description of the
parameters.
Parameter
Description
Description
Click on the VC to set the values for the
connection.
VPI/VCI
Virtual Path Identifier (VPI) and Virtual Circuit
Identifier (VCI).
Encapsulation
Specifies how to handle multiple protocols at the
ATM transport layer.
• VC-MUX - Point-to-Point Protocol over ATM Virtual
Circuit Multiplexer (null encapsulation) allows only
one protocol running per virtual circuit with less
overhead.
• LLC - Point-to-Point Protocol over ATM Logical
Link Control (LLC) allows multiple protocols
running over one virtual circuit (using slightly more
overhead).
Protocol
Protocol used for the connection