Filter
Top Products
30
Manually Configuring your Modem-Router
Manually Configuring your Modem-Router
31
section
2
1
3
4
5
6
7
Click Add or Edit to
display the following page
and add a new static route
to the list.
Parameter
Description
Index
Displays the number of the route.
Network
Address
Enter the IP address of the remote computer for
which to set a static route.
Subnet Mask
Enter the subnet mask of the remote network for
which to set a static route.
Gateway
Enter the WAN IP address of the gateway to the
remote network.
RIP Parameter
The device supports
Routing Information
Protocol (RIP) v1 and v2
to dynamically exchange
routing information with
adjacent Modem-Routers.
Parameter
Description
RIP mode
Globally enables or disables RIP.
Auto summary
If Auto summary is disabled, then RIP packets will
include sub-network information from all sub¬net
works connected to the ADSL Modem-Router.
If enabled, this sub-network information will be
summarized to one piece of information covering
all sub-networks.
Interface
The WAN interface to be configured.
Operation
Mode
Disable: RIP disabled on this interface.
Enable: RIP enabled on this interface.
Silent: Listens for route broadcasts and updates
its route table. It does not participate in sending
route broadcasts.
Version
Sets the RIP version to use on this interface.
Poison Reverse
A method for preventing loops that would cause
endless retransmission of data traffic.