Filter
Top Products
12
INSTALLATION
Installation Procedure for Windows XP
This installation procedure will successfully install two USB 1.1 OHCI
controllers, one USB 2.0 EHCI host controller, and one IEEE 1394 host
controller.
Important Note: There are two methods of installing the required USB 2.0
drivers in Windows XP.
If you have an Internet connection:
Windows XP checks the Windows update website and downloads the most
recent version of Microsoft USB 2.0 support drivers. Please proceed to
the “With Internet Connection” section.
If you do not have a connection to the Internet:
USB 2.0 drivers will be installed from the Belkin F5U508 installation CD.
Please proceed to the “Without Internet Connection” section.
With Internet Connection
1. Make sure your computer is completely powered down.
2. Remove the computer’s cover and locate an empty PCI slot.
3. Remove the port cover that corresponds with the PCI slot you wish to
use. (The cover is usually held in place with a single screw.)
4. Insert the PCI Card into the slot. Apply pressure as needed until the
card is fully seated. Secure the PCI card with the screw removed in
step #3, above.
5. After installing the PCI Card, replace the outer cover and turn on the
computer.
6. When Windows restarts the PCI card will be detected and drivers for
the IEEE 1394 host controller, and the two USB OHCI host controllers
will be automatically installed.
P73954ea-A_F5U508ea_uk 28-03-2003 14:27 Page 12