Filter
Top Products
Chapter 4 Accessory Boards
21
Accessory
Board
Retainer
Accessory Board Guide
Release Tab
Figure 4-4. Accessory Board Retainer and Guide
3. Install the boards. Insert each board in the desired slot and fasten the
board’s mounting screw at the slot opening at the rear of the chassis.
Connect any required cables to the boards. If you removed the board
retainer, reinstall it.
NOTE If you install an ISA non-Plug-and-Play board, you must
reserve system resources (some or all of: memory addresses,
I/O addresses, IRQs, and DMA channels) for it. Write down
that information now for reference when you reserve system
resources. See "Configuring the NetServer" for details of using
ISA Plug and Play boards.
4. Replace cover 1. (See Chapter 3, "Removing and Replacing Covers.")