Filter
Top Products
Page 14
In Windows NT, you can perform the
same installation as in the Windows 95
/98 procedure above. Make sure the power
supply is connected to the Bitronics switch,
otherwise, there may be a significant delay
in the processing of requests from NT-based
machines.
The Printer properties in Windows NT is
slightly different. After installing the
software and restarting the computer, go
the printer properties and select the PORTS
tab. To find the correct ports to be used
with the Bitronics switch, you must scroll
down the list until the “LPx1: PA
(autoswitch)” comes up. Put a checkmark
on the port that connects to the printer. In
this case, it is Port A on the Bitronics switch:
To set the spool settings correctly, click on
the SCHEDULING tab. Make sure “Start
printing after last page is spooled” is
selected. Also, set “Priority” to highest:
Click OK when done.