Filter
Top Products
43
Step 4: Configuring your Belkin Wireless Cable/DSL Router
(the Router) for connection to the Internet
To begin browsing the Internet, log out of the setup utility by clicking on
the “Logout” button. Once you have logged out, type a web address such
as www.belkin.com into the browser’s address bar. The browser should
take you to the web address you entered. Other computers you have
connected to the router should also have access to the Web. If you are
having problems, see the troubleshooting section of this manual.
PPPoE
If you have a DSL modem and your Internet Service Provider gave you
software such as WinPOET or Enternet300 that you use to connect to the
Internet, follow these steps to set up your Router for PPPoE.
1. It is recommended that you uninstall the software that your ISP
provided to you for connecting to the Internet. Before uninstalling the
software from your computer, be sure you have a copy of the software
in the event you want to re-install it at some point. If you do not
uninstall the PPPoE software provided to you by your ISP, your
connection may not work properly. To uninstall the software, Click on
“Start” then “Settings” then “Control Panel”.