Filter
Top Products
Quick Set up
6
If you are familiar with networking, you can use this Quick Setup
procedure to setup your Router. If you need more detail to setup your
Router, please read further into this manual.
Setting up the Router is accomplished in 3 easy steps
1. Connect the Router to your network.
2. Configure your computers' networking settings.
3. Configure the Router to your ISP’s settings.
Connect the Router to your network.
1. Power down your equipment.
2. Connect a network cable between each of your PCs and the Router.
Connect each PC to one of the ports on the rear of the Router
labeled LAN.
3. Connect a network
cable between the
Router and your
cable or DSL
modem. Be sure
this cable is
plugged into the port
labeled “WAN” on
the Router.
4. Power on the cable
or DSL modem.
5. Connect the
power adapter to
the Router.
6. After the cable or DSL modem and the Router are turned on, the Router’s
WAN link light should be on. This indicates that the modem and the
Router are connected to each other.
7. Turn on the rest of your computers. After your computers boot up, a LAN
link light (on the front of the Router) will be on for each port to which a
wired computer is connected. These lights are your means to verify that
your computers are connected.
Quick Set up–Setting up Your Belkin Wireless Cable/DSL Router