BenQ MP620 Projector User Manual


 
Operation26
To set a password:
CAUTION: Once a password has been set, the projector cannot be used unless the correct
password is entered every time the projector is started.
1. Open the on-screen menu and go to Setting > Password. Select On by pressing
Left 3or Right4.
2. When the function is activated for the first time,
a prompt will display on the screen. Use the Up
5 or Down 6 button to select a number for
each digit of the password. Use the Left 3 or
Right4 button to move between the digits of
the password.
3. When all digits are entered and the password is
ready, press Auto to confirm. A confirmation message displays.
The password will display on-screen when being input.
IMPORTANT: Write your selected password down here in this manual so that it is
available to you should you ever forget it.
Password: __ __ __ __
Keep this manual in a safe place.
4. Perform one of the following 3 steps.
i. Press Auto to continue. The set-up is finished when the message “Password setup
completed” displays.
ii. Press Up 5 to go back to the
previous screen and re-enter four
digits.
iii. Press Down 6 to cancel the
password set-up and return to the on-screen menu.
If you forget the password:
You will be asked to enter the four digit password every time you turn on the projector. If
you enter the wrong password, the password error message displays. You can retry by
pressing Up 5, pressing Power to turn off the projector and start again, or if you did not
record the password in this manual, and you absolutely do not remember it, you can use the
password recall procedure.
To enter the password recall procedure:
Press and hold Right4 for 5 seconds. The projector will display a coded number on the
screen. Seek help from the local BenQ service center to decode the number. You may be
required to provide proof of purchase documentation to verify that you are an authorized
user of the projector.
To change the password:
1. Open the on-screen menu and go to Setting > Change Password.
2. Press Left 3 or Right4. A “Password Change” message displays.
3. Enter the old password.
i. If the password is correct, you can go on to enter new password.
Password Setup
Enter Password
Press Auto to Confirm
Press 5 or 6 to change number
Press 3 or 4to move
0
0
00
Password Setup
Do you want to use 0 0 0 0 as your password?
Yes Auto No 5 Cancel 6