Filter
Top Products
Maintenance 41
A warning message like the one pictured to
the right will be displayed for 10 seconds
every 500 hours to remind you to clean the
filter. To leave the message, press the Exit
button on the projector or remote control.
To clean the filter:
1. Turn the projector off and wait until the fans stop running.
2. Disconnect the projector from any cables.
3. Locate the filter case on the back of the
projector.
4. Release the filter case from the projector by
pressing the filter case into the slot slightly. The filter case
springs out of the slot.
5. Pull out the filter case.
6. Use a small vacuum cleaner designed for
computers and other office equipment to clean the
filter sponge. Or use a soft brush (such as a clean
artist’s paintbrush) to gently sweep the dust on the
filter away.
If the dirt is difficult to remove or the filter is
broken, replace it with the supplied spare filter
sponge. See "How to replace the filter sponge:"
below.
Please check if the filter is clean
Clean the filter or replace with a new one
Press “Exit” to leave
filter case