Filter
Top Products
Operation
31
4. If the projector is activated for the first time,
select your OSD language following the on-
screen instructions.
5. If you are prompted for a password, press the
arrow keys to enter a six digit password. See
"Utilizing the password function" on page 35
for details.
6. Switch all of the connected equipment on.
7. The projector will start to search for input
signals. The current input signal being scanned
displays in the screen. If the projector doesn't
detect a valid signal, the message 'No Signal'
will continue displaying until an input signal is
found.
You can also press SOURCE on the projector or remote control to select your
desired input signal. See "Switching input signal" on page 37 for details.
If the frequency/resolution of the input signal exceeds the projector's operating range, you will
see the message 'Out of Range' displayed on a screen. Please change to an input signal which is
compatible with the projector's resolution or set the input signal to a lower setting. See "Timing
chart" on page 101 for details.