Filter
Top Products
12
Important safety instructions
Remote control
1. POWER ON/OFF
Toggles the projector between on and off mode.
2. Source selection keys
Selects an input source for display.
3. MENU/EXIT
Turns on the On-Screen Display (OSD) menu.
Goes back to previous OSD menu, exits and
saves menu settings.
4. Left
Decreases the projector volume.
When the On-Screen Display (OSD) menu is
activated, the #4, #15, and #17 keys are used as
directional arrows to select the desired menu
items and to make adjustments.
5. MODE/ENTER
Selects an available picture setup mode.
Activates the selected On-Screen Display
(OSD) menu item.
6. ECO BLANK
Used to blank the screen picture.
7. PIP
Displays the
PIP (Picture In Picture) menu.
8. ASPECT
Selects the display aspect ratio.
9. Picture quality adjustment keys
These function keys perform the same tasks as
specified in the OSD menu. For details, please
refer to "Fine-tuning the picture quality" on
page 30.
10.FINE TUNE
Displays the "Color Temperature Fine
Tu n in g" menu. For details, please refer to "To
save and leave the settings, press MENU/EXIT."
on page 32.
11.3D/INVERT
Enters the "3D" menu directly and toggles the
invert function between on and off.
12.MUTE
Toggles projector audio between on and off.
13.FREEZE
Freezes the projected image.
14.LIGHT
The LED backlight lights up and stays on for
approximately 10 seconds when pressing any
key on the remote control. Pressing any other
keys within the 10-second window turns off the
LED backlight.
15.Keystone/Arrow keys ( / Up, /
Down)
Manually corrects distorted images resulting
from an angled projection.
When the On-Screen Display (OSD) menu is
activated, the #4, #15, and #17 keys are used as
directional arrows to select the desired menu
items and to make adjustments.
16.AUTO
Automatically determines the best picture
timings for the displayed image.
17. Right
Increases the projector volume.
When the On-Screen Display (OSD) menu is
activated, the #4, #15, and #17 keys are used as
directional arrows to select the desired menu
items and to make adjustments.
18.SOURCE
Displays the source selection bar.
19.SRS
Enables or disables the SRS function.
20.TEST
Displays the test pattern.
1
2
3
6
7
8
10
12
13
11
16
18
20
19
17
14
15
15
4
5
9