Filter
Top Products
27
Important safety instructions
Wireless transmitter synchronization
The factory default configuration will pair your HDMI source device with the projector. If the connection
fails, follow the procedures below to set the pairing.
1. Connect the wireless transmitter to an HDMI source device. (e.g. Blu-ray, DVD player, AV-R player,
set top boxes, or games consoles)
2. Turn on the projector.
3. Select Wireless in the source selection bar.
4. Press MENU/EXIT on the projector or remote control, and select the System Setup menu.
5. Set Wireless Sync to On.
When Wireless Sync is on, the projector will not respond to any key commands from the projector or
remote control, except the power [On] and power [Off] keys. If you've accidentally started this function,
please re-start the projector to save the settings.
6. Press the buttons on the remote control in the following sequence:
(for 3 ~ 6 seconds) > > .
Please point the remote control toward the IR sensor on the rear of the projector.
7. When the Select Video Source menu displays, select Settings.
8. In the Settings menu, select Add New Video Source.