Filter
Top Products
20
SERVSWITCH™ WIZARD EXTENDER
3.2 Placement
NOTE
If you’d like to put an Extender module in a space in which its
rackmount-enabling endplate doesn’t fit well, or if you need to remove
its endplate for whatever other reason, you can do so by unscrewing the
two end-mounted screws that hold it on.
The ServSwitch Wizard Extender’s transmitter and receiver modules are designed
to be mounted in a ServSwitch Wizard Extender Chassis (ACU5000A), which in
turn is designed to be mounted in a standard 19" equipment rack. To mount a
module in an Extender Chassis, take these steps, referring to Figure 3-1:
1. Slide the module into the chassis with the protruding tip of its endplate
pointing upwards.
2. Screw the included pan-head screw through the hole at the top of the
module’s endplate and the matching hole in the front flange of the chassis in
order to secure the module to the chassis.
To mount the chassis itself, hold its side flanges against the vertical rails of your
rack, then use four of your own screws, bolts, cage nuts, etc., to secure the flanges
to the rails.
Figure 3-1. Mounting a module in an Extender Chassis.
ServSwitch Wizard
Extender Chassis
(ACU5000A)
Extender
module
Included M3
pan-head screw
for attaching the
module to the
chassis