Filter
Top Products
Installing the ET0010A
ETEP Installation Guide 27
The steps to perform for a typical installation are listed below.
Cabling Requirements: ET0010A
Table 12 outlines the standard cables used with each port on the ETEP. The connector type listed
indicates only what is required to connect to the ETEP port, and may or may not be the same connector
type required for the other end of the cable. Some cables are supplied by Black Box and others are user-
supplied.
Unpacking the Shipping Carton: ET0010A
Remove all product components from the shipping carton and compare the contents to the packing list.
Keep all packaging in case it is necessary to return the unit.
The ETEP is packaged with the standard items listed below. Additional cables, country-specific power
cords, and other accessories can be ordered separately.
1 ET0010A
● Firmware and software is factory-installed on the unit.
2 Accessory Kit
● (1) Power cable (US)
● (1) Power supply
Table 11 Installation Steps
Step Action to Perform Description
1 Review the cabling requirements. on page 27
2 Unpack the shipping package. on page 27
3 Install the ETEP in a rack or on a solid surface. on page 28
4 Connect the cables. on page 33
5 Apply power to the ETEP. on page 34
Table 12 ET0010A Standard Cables
ETEP Port Cabling Supplied by...
Power receptacle Power supply and power cable Black Box
RS-232 port 1.8 meter shielded null modem
cable with an RJ45 connector at
one end and a DB9 female
connector at the opposite end.
Black Box
Ethernet Management Port Unshielded Category 5 straight
through cable (UTP), RJ-45
connectora.
Black Box
Aux1 port Not applicable. Port is not
enabled in this release.
Not applicable
Remote and Local ports (2) Unshielded Category 5
straight through cables (UTP),
RJ-45 connector
a
a. The local, remote, and Ethernet management ports are auto-sensing for polarity. You can use shielded Category 5
straight through cables or crossover cables when connecting to these ports.
User