Black Box EncrypTight Enforcement Point (ETEP) Installation Guide Network Hardware User Manual


 
Installing the ET1000A
ETEP Installation Guide 41
NOTE
To meet the requirements of FCC Part 15 and the EU EMC Directive 2004/108/EC, use only shielded
Category 5 cables with the ET1000A Ethernet management port.
Unpacking the Shipping Carton: ET1000A
Remove all product components from the shipping carton and compare the contents to the packing list.
Keep all packaging in case it is necessary to return the unit.
The ET1000A is packaged with the standard items listed below. Additional cables, country-specific power
cords, SFPs, and other accessories can be ordered separately. A list of approved transceivers is included
in the ETEP Release Note.
1 ET1000A chassis
Firmware and software is factory-installed on the unit.
2 Accessory Kit
Rack mount kit includes 2 mounting brackets, 4 large screws (#10-32), and 8 small black screws
(2) Power cables (US)
(1) 6 ft. shielded DB-9 null modem cable (female to male)
(1) 6 ft. shielded Category 5 straight through cable (STP) with RJ-45 connector
CD containing user documentation and a backup copy of the ETEP software
Rack Mount Installation: ET1000A
The ET1000A can be mounted in a standard 19-inch rack using the mounting kit, or simply placed on a
rack shelf or solid surface. Before installing the ET1000A in a 19-inch rack, review the rack-mounting
guidelines listed in “ETEP Site Preparation” on page 25.
To mount the ET1000A in a standard 19-inch equipment rack, have the following tools and materials
available:
Two mounting brackets, supplied in the Accessory Kit
8 small black screws and (4) large #10-32 screws, supplied in the Accessory Kit
#1 Phillips and #2 Phillips screwdrivers (user-supplied)
CAUTION
In order to safely and securely and install the ET1000A in a rack, you must use the mounting brackets
supplied in the Accessory Kit. Other brackets may fail to properly support the weight of the ET1000A.