Filter
Top Products
Installation
44 ETEP Installation Guide
Figure 31 Dual power supplies on the ET1000A rear panel
To power on the ET1000A:
1 On the appliance’s rear panel, plug the power cords into the power receptacles for each power supply.
2 Attach the opposite end of the first power cord to a power source. Attach the second power cord to a
a power source on a different circuit. The power supply status LED illuminates when power is
applied.
3 After the power cords are plugged in, secure the cords using the clips on the rear of the unit.
Figure 32 The power cord for power supply # 1 is secured with a clip
Elements of Figure 31:
1) Power cord clips
2) Status LED for power supply 2
3) Power receptacle for power supply 2
4) Power receptacle for power supply 1
5) Status LED for power supply 1