Filter
Top Products
Installation
42 ETEP Installation Guide
To install the ET1000A in a rack:
1 Place the unit on a solid surface, with the top facing up. Position the mounting brackets on each side
of the appliance, as shown in Figure 27.
Figure 27 Mounting bracket orientation
2 Attach the mounting brackets to each side of the unit using the 8 small black screws provided in the
accessory kit, and a #1 Phillips screwdriver, as shown in Figure 28.
Figure 28 Each bracket is attached to the side of the ET1000A using four screws
3 Attach the mounting brackets to the rack’s front support with the large #10-32 screws, using a #2
Phillips screwdriver. Insert two screws in each bracket, using the top and bottom holes (Figure 29).
Figure 29 Front view of mounting brackets
Connecting the Cables: ET1000A
Follow the instructions below to connect the ET1000A to the appropriate network devices (see Figure
30).