Filter
Top Products
Chapter 4: Configuration
724-746-5500 | blackbox.com
Page 23
4.2.5 Miscellaneous functions
To reset configuration to factory defaults
1. Enter the Configuration menu (see Section 4.1 for details).
2. Press F to enter the Functions menu
3. Press 8 and then Enter. The display will show r momentarily.
4. Press E and then Enter to exit the menu and save changes.
To show the current firmware version
1. Enter the Configuration menu (see Section 4.1 for details).
2. Press F to enter the Functions menu
3. Press 1 and then Enter.
The display will blank for a short while and then the major number of the firmware revision will be shown. The display will
blank again and then show the first digit of the minor number. Following another blank, the second digit of the minor number
will be displayed. e.g. <blank> 1 <blank> 0 <blank> 2 <blank> equals v1.02
4. Press E and then Enter to exit the menu and save changes.
To set a new password
1. Enter the Configuration menu (see Section 4.1 for details).
2. Press P
and then Enter. The display will show
3. Enter a new password and then Enter. See Section 5.2 Locking Access to the Computers.
4. Press E and then Enter to exit the menu and save changes.