Filter
Top Products
ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL
248
A.2.8 PING GROUP
PING: Invalid packet size
You have entered a ping command with the packet-size parameter specified to be larger than 512K.
The maximum Router ping packet size is 512K. Try the command again with a smaller packet size
parameter.
PING: No known DNS servers
No domain name server is present in the current Router configuration, or no domain servers are
present. If you are using Domain Name Service, use the config modify command to add one or more
domain name servers to your configuration.
PING: Resolving host_name...
This message is displayed initially after entering your TCP/IP command, while the resolver is attempting
to map host_name to an IP address. If the mapping is unsuccessful, the message is displayed.
PING: Unknown host: host_name
An attempt to ping host_name failed because the Router was an unable to resolve the given host_name to
an IP address. Check routing to the name server and verify that Name Service is running. Try entering
the IP address of the destination host rather than the host_name.
A.2.9 PPP G
ROUP
PPP: Unknown interface: iface
The interface specified in the ppp command could not be found. Check for typos on the command
line, and re-enter the command line.
PPP: iface not a ppp interface
A ppp command was given with an incorrect interface. Enter the ifconfig command to display the
available interfaces, and re-enter your command line.
A.2.10 RIP G
ROUP
RIP: router_addr already in RIP filter table
The rip refuse command has already been entered for router_addr.
RIP: host_address not found in the RIP table
The rip delete or rip refuse command was unable to find the specified host_address in its table.
RIP: host_address unreachable
The rip add command was unable to find a route to the given host_address.
A.2.11 SNMP G
ROUP
SNMP: host_addr host address already in ACL
An attempt was made to add a host to the ACL whose address was already in the ACL table.
SNMP: Community: com_name not entered
A status or set command was entered without a com_name. Re-enter the command line and include the
com_name.