Filter
Top Products
ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER USER’S MANUAL
56
Router_name or IP_address
or add the following route command to the /etc/rc.local file:
route add remote_lP_addresslocal_Router_IP addressl
4. Proceed to the next section, and test your network using ping.
6.2 Test TCP/lP Networks Using Ping
To systematically verify connectivity, power up the Router and observe the messages on the console.
Establish a PPP connection on your WAN interface, using the update now command. If CHAP or PAP
hasn’t failed, then perform the “ping” tests. The ping tests provide a minimal set of results that can be
used to help verify network connectivity and resolve problems.
To perform all of the ping tests, you will require the help of an associate at the remote site. If an
associate is not available, then you can perform the first four ping tests.
On the diagram, circle the test numbers if the ping is successful, and record the IP addresses and
subnet masks used. If desired, fax these two completed diagrams to your technical-support person.
For more information, refer to ping in Section 4.10 of the Reference Guide, which begins on page 137.
If you perform all of the steps here and still have problems, refer to Appendix C of this manual.
Figure 6-1. Ping from the Local Ethernet.
system name
subnet (IP)
IP address
system name
subnet (IP)
IP address
system name
subnet (IP)
IP address
system name
subnet (IP)
IP address
You
ping
You
ping
Your associate
4
3
1
2
Async
Router
Async
Router