Filter
Top Products
17
USING THE PROJECTOR
This section describes how to use and make adjustments to the
projector. It also provides a reference to the keypad and remote
buttons and the options available from the on-screen menus.
Basic Image Adjustment
1 Make sure you have powered up your equipment in the right
order (page 15).
2 If the image doesn’t display completely, adjust the height and
tilt of the projector (page 19), zoom the image (page 19), or
center the image by adjusting its horizontal or vertical posi-
tion (page 30).
3 If the image is out of focus, rotate the lens to focus it (page 19).
4 If the image appears to shimmer or if it has blurry vertical
bars after you have adjusted the focus, turn Auto Image
(page 29) off and then back on to reset the automatic sync and
tracking. If that doesn’t clear up the image, adjust the sync
(page 29) and/or the tracking (page 30) manually.
5 If the colors don’t look right, adjust the brightness (page 22)
and tint (page 26).
Using the Remote Control
NOTE: If you can’t aim the
remote control at the projector so
that its signal is received
— for
example, when using rear projec-
tion
— connect the remote
directly to the projector with the
remote control cable.
Point the remote control at the projection screen or at the front or
rear of the projector. The range for optimum operation is about
25 feet. If you point the remote at the projection screen, the dis-
tance to the screen and back to the projector must be less than or
equal to 25 feet. For best results, point the remote directly at the
front or the rear of the projector.
The projector ships with a full-feature remote (see page 21 for a
description of the buttons) which includes a laser pointer. The
remote has a disk mouse and two mouse buttons, one on the top
of the remote and one on the bottom.