Filter
Top Products
92
Warning Messages:
Warning Messages are displayed for a period of five seconds. If multiple
Warnings are detected, the display will reflect the highest priority message.
Printer Warning Messages
Displayed Message Description Action(s)
The printer has
detected defective
printhead elements.
Replace the printhead if the
print quality becomes
unacceptable.
The printer measured
only a small
difference between
the ‘empty’ and ‘gap’
sensor readings.
Transparent backing or
notched media typically
gives this indication. In this
case, there may be a slight
delay in the ‘Out of Stock’
indication, after the media
supply is emptied; no
action is required.
Power has been
removed and
shutdown is in
progress.
The printer power switch
was turned ‘Off’, the line
fuse has blown, or AC line
voltage has been lost.
The host has pending
configuration
changes that will not
take effect until a
‘host reset command’
is issued.
To save changes, send a host
reset command (in DPL), or
to discard changes perform a
soft reset; see Section
4.0.6.1.
The printer has
detected a low
operating voltage.
Possible low or fluctuating
line voltage level. Try
moving the printer to
another outlet. If the
condition persists, call for
service.
The printer was
unable to save
settings in permanent
memory.
Possible faulty Main PCB.
If the condition persists, call
for service.
A high printhead
temperature has been
detected.
No action required.