Filter
Top Products
Control panel setup
113
10
IPv6
This printer is compatible with IPv6, the next generation internet protocol. If you want to use the IPv6
protocol, visit http://solutions.brother.com
for more information.
Ethernet 10
Ethernet link mode. Auto allows the print server to operate in 100BASE-TX full or half duplex, or in 10BASE-T
full or half duplex mode by auto negotiation.
100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and 10BASE-T Full Duplex (10B-FD) or Half
Duplex (10B-HD) fix the print server link mode. This change is valid after the print server has been reset. The
default setting is Auto.
Note
If you incorrectly set this value, you may not be able to communicate with your print server.
Set to Default 10
You can restore the Wired menu settings to factory default.
Wired Enable
10
You can enable and disable the wired network connection by selecting On or Off.
WLAN menu options (HL-4070CDW only) 10
See Wired menu options on page 111 for detailed information of the Wired menu option.
TCP/IP 10
See TCP/IP on page 111 for more information.
Setup WLAN
10
Setup Wizard
The Setup Wizard guides you through the wireless network configuration. For more information, see Using
the Setup Wizard from the control panel on page 28.
SecureEasySetup
The SecureEasySetup™ software allows you to configure the wireless network easier than configuring it
manually. By pushing a button on the wireless router or access point, you can complete setup and secure
the wireless network. Your router or access point must also support SecureEasySetup™. See Using the
SecureEasySetup™ software to configure your printer for a wireless network on page 23.