Filter
Top Products
Control panel setup
118
10
Disabling the APIPA protocol 10
If the APIPA protocol is enabled, the print server will automatically allocate a Link-Local IP address in the
range (169.254.1.0 - 169.254.254.255) when the print server cannot obtain an IP address through the
BOOT Method you have set.
By default, the APIPA protocol is enabled. You can disable the APIPA protocol using the BRAdmin Light utility
or Web Based Management (web browser). For more information, see Changing the print server
settings on page 15.
You can also disable the APIPA protocol using the control panel on the top of the printer. Please follow these
steps:
a Make sure that the power cord is plugged in.
b Turn on the printer and wait until the printer is in the Ready state.
c Press any of the Menu buttons (+, -, OK or Back) to take the printer off line.
d Press the + or - button to select LAN, and press OK.
For HL-4040CN / HL-4050CDN users: Go to stepf
For HL-4070CDW users: Go to step e
e Press + or - button to select Wired or WLAN that you want to change, and press OK.
f Press + or - button to select TCP/IP, and press OK.
g Press + or - button to select APIPA, and press OK.
h select Off using + or - button, and press OK. The APIPA protocol has been set to be disabled.
Note
For more information on APIPA, see Chapter 1 or Chapter 2.