Filter
Top Products
58
LENGTH
LIMIT!
• This message appears if the text is
longer than 1 metre when you try to
print.
• Shorten the text to less than 1
metre before trying to print.
• This message appears if the Length
function is used to set a label
length that is less than 4.0 cm or
more than 30.0 cm.
• Set the label length between
4.0 cm and 30.0 cm.
• This message appears if the Tab
Length function is used to set a tab
length that is more than 30.0 cm.
• Set the tab length so that it is
less than 30.0 cm.
LINE
LIMIT!
This message appears if the number
of lines in the text is greater than the
maximum number of lines possible
for the installed tape.
Reduce the number of lines or
install a tape of greater width.
MEMORY
FULL!
This message appears if you try to
store a text file after the maximum
number of characters has already
been stored in the memory.
Delete an unwanted file to make
room for the new one.
NO
FILES!
This message appears if you try to
recall or delete a text file from the
memory when none are stored.
Store a text file first.
NOT
HERE!
This message appears if the cursor is
at the end of the text when you try to
use the Numbering function.
Move the cursor below a
number before trying to use the
Numbering function.
OVERFLOW This message appears if the calcu-
lated currency conversion result
exceeds 10 digits.
Enter a smaller value.
REPLACE
BATTERIES!
This message appears if the installed
alkaline batteries are about to run
out.
Replace the batteries or use the
AC adaptor.
ROM
PROBLEM!
This message appears if there is a
problem with the machine’s read
only memory.
Turn off the machine, and then
while holding down c and
R, turn the machine back on.
Contact your service representa-
tive.
Error Message Cause Remedy