Filter
Top Products
INTRODUCTION 1 - 7
Red
Service error Follow the steps below.
1. Turn off the power switch.
2. Wait a few seconds, and then turn it
back on and try to print again.
If you cannot clear the error and still see
the Red back light after turning the MFC
back on, please call your Brother dealer or
Brother authorized service center.
Cover open The cover is open. Close the cover. (See
Error messages on page 12-1.)
Toner empty Replace the toner cartridge with a new
one. (See Replacing the toner cartridge
on page 12-25.)
Paper error Put paper in the tray or clear the paper
jam. Check the LCD message. (See
Troubleshooting
on page 12-1.)
Out of memory Memory is full. (See
Error messages
on
page 12-1.)
Other errors Check the LCD message. (See
Troubleshooting on page 12-1.)
LCD MFC status Description