Brother DCP-195C All in One Printer User Manual


 
66
Cannot Print
Replace XX Ink
One or more of the ink cartridges
have reached the end of their life.
The machine will stop all print
operations.
Replace the ink cartridges. (See Replacing
the ink cartridges on page 71.)
Cover is Open The scanner cover is not closed
completely.
Lift the scanner cover and then close it
again.
Clean Unable XX The machine has a mechanical
problem.
OR
A foreign object such as a clip or
ripped paper is in the machine.
Open the scanner cover and look inside
the machine for any foreign objects. If the
error message continues, disconnect the
machine from the power source for several
minutes and then reconnect it.
Close Ink Cover The ink cartridge cover is not
completely closed.
Firmly close the ink cartridge cover until it
clicks.
Data Remaining Print data is left in the machine's
memory.
Press Stop/Exit. The machine will cancel
the job and clear it from the memory. Try to
print again.
High Temperature The print head is too warm. Allow the machine to cool down.
Hub is Unusable. A Hub or USB Flash memory
drive with a Hub has been
connected to the USB direct
interface.
A Hub or USB Flash memory drive with a
Hub are not supported. Unplug the device
from the USB direct interface.
Init Unable XX The machine has a mechanical
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
Open the scanner cover and look inside
the machine for any foreign objects. If the
error message continues, disconnect the
machine from the power source for several
minutes and then reconnect it.
Ink Low Black
Ink Low Yellow
Ink Low Cyan
Ink Low Magenta
One or more of the ink cartridges
are running out of ink.
Order a new ink cartridge. You can
continue printing until the LCD shows
Cannot Print.
Low Temperature The print head is too cold. Allow the machine to warm up.
Media Error The memory card is either
corrupted, incorrectly formatted,
or there is a problem with the
memory card.
Put the card firmly into the slot again to
make sure it is in the correct position. If the
error remains, check the media drive (slot)
of the machine by putting in another media
card that you know is working.
Media is Full. The memory card or USB Flash
memory drive you are using
already contains 999 files.
Your machine can only save to your
memory card or USB Flash memory drive
if it contains less than 999 files. Try
deleting unused files to free some space
and try again.
No Cartridge An ink cartridge is not installed
correctly.
Take out the new ink cartridge and
re-install it slowly until it clicks. (See
Replacing the ink cartridges on page 71.)
Error Message Cause Action