Filter
Top Products
Confidential
9-19
S-2
Although the USB driver is installed, it is unable to find the BRUSB: port.
(Windows98/Me only)
User Check
(1) Re-install the USB driver by following the steps below;
i) Turn the printer off.
ii) Double-click the file “Deins USB.exe” in the USB directory of the CD-ROM.
iii) Re-boot the PC.
iv) Turn the printer on.
v) “Add New Hardware Wizard” is launched again, follow the instructions in the
Wizard tore-install the driver.
(2) Try to connect the printer directly to the computer if it is connected through a USB hub.
Possible cause
Step
Check
Result
Remedy
Computer
Operating
System
1 Windows 95 or Windows
NT4.0?
Yes The operating system does not
support USB.
Computer
settings
2 Does ‘Universal Serial Bus
Controllers’ appear in the
Device Manager tab of
‘System Properties’ in
Control Panel?
No This problem can be caused by
your computer settings. See the
computer manual.
USB cable/
printer
damage
3 Does “Add New Hardware
Wizard” appear on the
screen or Does test print
complete?
No The USB cable is damaged.
Replace the cable. If the same
problem appears, the printer will
be damaged.