Filter
Top Products
9 - 8
MESSAGE CENTER (FOR FAX-333MC ONLY)
Remote Retrieval
Using Remote Retrieval Access Code
1
Dial your fax number from a touch tone phone.
2
When your fax machine answers, immediately enter your Remote Retrieval Access
Code.
3
The fax machine signals the kinds of messages received:
1 long beep—Fax message(s)
2 long beeps—Voice message(s)
3 long beeps—Fax and Voice message(s)
No beeps—no messages
4
The fax machine then prompts you with two short beeps to enter a command. If you
wait longer than 30 seconds to enter a command, the MFC hangs up. If you enter an
invalid command, the fax machine beeps three times.
5
Press 9 0 to reset the fax machine when you finish.
6
Hang up.
Changing Remote Retrieval Access Code
Enter your Remote Retrieval Access Code when the fax machine picks up your call,
so you can access features remotely. The access code is preset to 159 , but you can
change it.
1
Press Function/Set, 8, 7.
2
Enter a three-digit number from 000 to 999 and press Function/Set. The “ ”
cannot be changed.
3
Press Stop to exit.
If your fax machine is set to MANUAL mode, you can access the Message Center by
waiting about 2 minutes, then entering the Remote Access Code within 30 seconds.
Do not use the same digits that appear in your Fax Receive Code or Telephone
Answer Code.