Filter
Top Products
Quick-Dial numbers and dialing options
7 - 6
Speed-Dialing
1
Pick up the handset.
—OR—
Press Hook.
2
When you hear a dial tone, press Search/Speed Dial, press
#, and then press the two-digit Speed-Dial number.
3
If you pressed Hook to dial the call, pick up the handset when
the other party answers. (The speaker works only one way;
the other party won’t be able to hear you unless you pick up
the handset.)
4
To hang up a voice call, replace the handset.
Access codes and credit card numbers
Sometimes you may want to choose from several long distance
carriers when you make a call. Rates may vary depending on the
time and destination. To take advantage of low rates, you can store
the access codes or long-distance carriers and credit card
numbers as One-Touch and Speed-Dial numbers. You can store
these long dialing sequences by dividing them and setting them up
on separate keys in any combination. Make sure you have
selected CHAIN as the type of number when you stored the
beginning portions of a long number.
The combined number will be dialed in the order that you entered
it as soon as you press Fax Start.
(See Storing Speed-Dial numbers on page 7-2.)
Perhaps you have stored ‘555’ on Speed-Dial #03 and ‘7000’ on
Speed-Dial #02. If you press Search/Speed Dial, #03,
Search/Speed Dial, #02, and Fax Start, you will dial ‘555-7000’.
To temporarily change a number, you can substitute part of the
number with manual using the dial pad.
For example, to change the number to 555-7001 you could press
Search/Speed Dial, #03 and then press 7001 using the dialing
pad.
■ If the LCD shows NOT REGISTERED when you press the
Speed-Dial 2-digit number, a number has not been stored
for it.
■ If you are sending a fax, press Fax Start after entering the
Speed-Dial number. If you picked up the handset or
pressed Hook, press Fax Start when the receiving fax
machine answers with fax tones.
If you must wait for another dial tone or signal at any point in
the dialing sequence, store a pause there in the number by
pressing Redial/Pause. Each key press adds a 3.5-second
delay.
#05:
ENTER & SET