Filter
Top Products
4 - 4
Initial Setup
Setting the Beeper Volume
You can change the beeper volume. The default (factory) setting is
LOW. When the beeper is on, the fax machine will beep when you
press a key, make a mistake or after you send or receive a fax.
1
Press Menu/Set, 1, 4.
(LOW, HIGH or OFF)
2
Press ▲ or ▼ to select your option.
Press Menu/Set.
3
Press Stop/Exit.
Setting the Speaker Volume
You can adjust the speaker volume.
1
For FAX-T104, lift the handset and press Tel.
For FAX- T106, press Speaker Phone.
2
Press or to adjust the volume level.
The LCD shows the setting you are choosing. Each key press
changes the volume to the next setting. The new setting will
remain until you change it again.
3
For FAX-T104, press Tel.
For FAX- T106, press Speaker Phone.
(FAX-T106 only)
■ You can adjust the speaker volume using or
while you are listening to your OGM (Outgoing Message)
and ICMs (Incoming Messages).
■ If you turn Incoming Recording Monitor to OFF (Menu/Set,
8, 6) the Speaker for screening calls will be disabled and
you won’t hear callers leaving messages. The volume for
other operations can still be controlled using or .
4.BEEPER
▲
▲