Filter
Top Products
GT-3 Series
5. Maintenance
31
5. Maintenance
For optimum product performance regular maintenance is required.
DANGER
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the
wall outlet before opening the right-side cover of the control unit. Do not touch as high voltage can
result in severe injury.
CAUTION
Wait at least 1 minute after turning off the power switch before opening the front cover.
Do not touch the head heat sink as it may be HOT and may cause a bum.
Be careful not to get your fingers caught when closing the front cover, otherwise it may result in injury
to your fingers.
Do not move the Platen by hand.
The Printer may be seriously damaged by this.
Do not disassemble the ink cartridge.
Take care not to let the liquids: Ink, Wash Liquid, Maintenance Solution, Pretreatment or waste liquid
come into contact with your eyes or onto your skin, otherwise inflammation can result. In case of
contact with eyes, do not rub but immediately rinse the eyes with water.
Furthermore, do not drink the liquids: Ink, Wash Liquid, Maintenance Solution, Pretreatment or waste
liquid under any circumstances, as they can cause vomiting and diarrhea.
Keep the liquids out of the reach of children.
Be sure to wear protective goggles and gloves when handling the grease, so that they do not get into
your eyes or onto your skin. If the grease get into your eyes or onto your skin, inflammation can result.
Furthermore, do not drink or eat the grease. They may cause diarrhea or vomiting.
Keep the grease out of the reach of children.
When replacing parts and installing optional accessories, be sure to use only genuine Brother parts.
Brother will not be held responsible for any accidents or problems resulting from the use of
non-genuine parts.