Filter
Top Products
ENGLISH
- 9 -
Setup
Turning the machine on/off
(1)Connect the plug of the AC adapter into the
DC connector.
(2)Plug the AC adapter into an electrical outlet.
(3)Turn the power dial on the control panel to
Cutter Off, Border or No Border. The green
light on top of the Start button will light up. If
the machine does not respond, check the
connection of the AC adapter.
To turn the machine off, turn the power dial to
POWER OFF.
(4)Press the Feed button until you can see the
edge of the film to remove any slack from the
film.
WARNING:
Do not plug your machine into an electrical outlet until it has been completely assembled.
Do not try to disassemble or repair this equipment yourself. Service should be performed by
authorized personnel only. Warranties will be voided if the unit is repaired by unauthorized
technicians.
Never touch the surface of the blades when installing the film cartridge.
CAUTION:
Do not turn the machine off during the laminating process.
The machine should be turned off during operation only in the event of a malfunction.
About Auto Power Saver
This machine has an Auto Power Off function. If the machine is left idle for approx. 5 minutes, the machine
will automatically turn off. In order to turn the machine back on, please turn the POWER dial to POWER
OFF, and then turn the machine on by selecting the cutter mode: Cutter Off, Border or No Border.
ONON OFF
Cutter Off
POWER
No Border
Border
StartStop