Filter
Top Products
Troubleshooting and Routine Maintenance
139
B
Unable to Clean XX The machine has a mechanical
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
Open the scanner cover and look inside
the machine for foreign objects and paper
scraps. If the error message continues,
see Transferring your faxes or Fax Journal
report on page 140 before disconnecting
the machine so you will not lose any
important messages.
Then, disconnect the machine from the
power source for several minutes and then
reconnect it.
Unable to Init. XX The machine has a mechanical
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
Open the scanner cover and look inside
the machine for foreign objects and paper
scraps. If the error message continues,
see Transferring your faxes or Fax Journal
report on page 140 before disconnecting
the machine so you will not lose any
important messages.
Then, disconnect the machine from the
power source for several minutes and then
reconnect it.
Unable to Print XX The machine has a mechanical
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
Open the scanner cover and look inside
the machine for foreign objects and paper
scraps. If the error message continues,
see Transferring your faxes or Fax Journal
report on page 140 before disconnecting
the machine so you will not lose any
important messages.
Then, disconnect the machine from the
power source for several minutes and then
reconnect it.
Unable to Scan XX The machine has a mechanical
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
Open the scanner cover and look inside
the machine for foreign objects and paper
scraps. If the error message continues,
see Transferring your faxes or Fax Journal
report on page 140 before disconnecting
the machine so you will not lose any
important messages.
Then, disconnect the machine from the
power source for several minutes and then
reconnect it.
Unusable Device
Disconnect device from
front connector & turn
machine off & then on
A broken device has been
connected to the USB direct
interface.
Unplug the device from the USB direct
interface, then press On/Off to turn the
machine off and then on again.
Error Message Cause Action