Filter
Top Products
20
9.11.3 Interval of Checking Connection
Interval timer to check connection with
destination host.
9.11.4 Retry Count
The number of times a retry will be at-
tempted when a failed connection is detected.
The retry is performed every 2 seconds.
9.11.5 Apply Device
Specify wireless device that is applicable Link
Integrity function.
9.11.6 Status
Link integrity status.
9.12 Wireless Distribution System
Settings
WDS is used for wireless communication
between access points. Allows the WLM2-
G54 to communicate with up to 6 other
WLM2-G54s. Since the communication
method is proprietary and is not defined in
Wi-Fi interoperable procedures, it communi-
cates to WLM2-G54s only, and not other
brands of APs. The WDS setup is the same as
repeater function setup.
• Add AirStation
• Connected AirStation
PART IV
10.0 Diagnostics
10.1 Introduction IV
Diagnostics is a convenient tool for monitor-
ing network operation and traffic.
10.2 Parameters for the Diagnostic
Operation
The following parameters are used: Unit
information, Packet information, Wireless LAN
PC information, Ping testing, Log information
and Setting initialization.
Figure 10.2.1 Unit Information
Figure 10.2.2 Transfer Packet Information