Cabletron Systems 6C105 Switch User Manual


 
Setting Up the 6C105
6C105 Overview and Setup Guide 3-3
3.2.2 Installing the Cable Management Bar
To install the cable management bar, proceed as follows:
1. Remove the cable management bar from the shipping box. Ensure that
there are four screws inside the bag with the cable management bar.
2. Refer to Figure 3-1. Line up the two holes on each side of the cable
management bar with the two holes located underneath the 6C105,
near the front of the chassis.
3. Using a Phillips screwdriver securely fasten the 4 screws.
Figure 3-1 Installing the Cable Management Bar
Bottom of Chassis
Front Panel of Chassis
Screws (4)
2016_05
Cable Management Bar