Filter
Top Products
Chapter 3: 6C105 Setup
3-16 6C105 Overview and Setup Guide
4. Slide the fan tray forward until the faceplate of the tray is flush with
the face of the 6C105. If there is any strong resistance, remove the fan
tray and reinsert it.
5. Once the tray is in place, tighten the slotted screws with a screwdriver
to secure the tray to the 6C105.
6. When the 6C105 is ready to be powered on, observe the LED on the
front of the fan tray. This LED should be red for a moment after the
power switch is turned on, and then change to green to indicate that all
fans are operating properly. If this LED remains red, it indicates that
one or more of the fans are not operating at the proper speed. Check
the fan tray to ensure that nothing is interfering with the movement of
the fans; also, check to make sure nothing is blocking the air vents on
the chassis or the fan tray. If the problem cannot be located, call the
Cabletron Systems Global Call Center for assistance.
!
CAUTION
The fan tray is hot swappable; however, the chassis must not
be run without the fan tray for extended periods of time, as it
will quickly overheat.