Filter
Top Products
3-1
CHAPTER 3
INSTALLATION
This chapter contains instructions for unpacking and installing the
7H02-06 Module in the 7C03, 7C04, 7C04-R MMAC SmartSwitch.
Also included in the chapter are instructions for the front panel
FEPIMs.
3.1 UNPACKING THE 7H02-06 MODULE
Unpack the 7H02-06 Module by using the following steps:
1. Carefully remove the module from the shipping box. (Save the
box and packing materials in the event the module must be
reshipped.)
2. Remove the module from the plastic bag. Observe all
precautions to prevent damage from Electrostatic Discharge
(ESD).
3. Carefully examine the module and check for damage. If damage
exists, DO NOT install the module; contact Cabletron Systems
Technical Support.
3.2 INSTALLING FEPIMS
The 7H02-06 module is shipped without an FEPIM. To install an
FEPIM, follow the procedure below:
1. Remove the module if it is installed in the 7C03 MMAC
SmartSwitch chassis (follow the procedure in Section 3.3.2.)
Note:
The procedure for removing the module depends upon the chassis
(7C03,7C04 or 7C04-R) the module is installed in. See the
applicable removal procedure contained within the following pages.
2. Remove the module faceplate by removing the 3 screws on the
bottom of the module. Carefully remove the module faceplate
exposing the slot for the FEPIM (see Figure 3-1).