![](http://pdfasset.owneriq.net/1/1d/11d91160-81a0-4f21-a2d0-42e701e568aa/11d91160-81a0-4f21-a2d0-42e701e568aa-bg14.png)
3-2
Installation
Figure 3-1. Module Bottom View
3. Remove the blank front cover over the FEPIM slot.
4. Install the FEPIM as shown in Figure 3-2. Ensure that the rear
connector is seated firmly before tightening the three mounting
screws.
Note:
Carefully push the FEPIM straight down once it is firmly seated
onto the module.
5. Re-install the module faceplate by adding the 3 mounting
screws to the bottom of the module.
Ejector Tab
Ejector Tab
Screws