Filter
Top Products
3-6
Installation
3.3.3 Installing the 7H02-06 Module in a 7C04 or 7C04-R
Chassis
To install the 7H02-06 Module in a 7C04 or 7C04-R Chassis, follow
the listed steps and refer to Figure 3-5 and Figure 3-6, respectively.
Notes:
The 7H02-06 Module cannot be installed in the top slot of the
7C04 Chassis. The top slot is reserved for the 7X00 SmartSwitch
Module.
The 7H02-06 Module cannot be installed in the bottom slot in the
7C04-R Chassis. The bottom slot is reserved for the 7X00
SmartSwitch Module.
Before installing the 7H02-06 Module, attach the wrist strap
included with the module (instructions are printed on the packet).
1. Remove the blank panel covering the slot in which the module
will be installed. All other slots in the chassis must remain
covered to ensure proper airflow and cooling.
2. Slide the module into the slot. Make sure the printed circuit
board (PCB) is between the card guides, slides in straight, and
engages the backplane connectors properly.
3. Use a slotted screwdriver to tighten the module’s front panel
screws.