Filter
Top Products
Installing the EPIM-100TX or the EPIM-100FX
SEHI100TX User’s Guide 4-9
4.6 INSTALLING THE EPIM-100TX OR THE EPIM-100FX
This section contains procedures on how to install the EPIM-100TX or
the EPIM-100FX to upgrade or change the capabilities of your SEHI.
After installing a new EPIM, refer to the appropriate EPIM section in
Appendix A to verify proper operation.
Install an EPIM-100TX or an EPIM-100FX as follows:
1. Remove the coverplate or the existing EPIM (whichever applies).
2. Slide the new EPIM into place, making sure that the connectors on the
rear of the EPIM align correctly and firmly with the connector inside
the SEHI. Refer to Figure 4-7.
3. Install the mounting screw.
Figure 4-7 Installing an EPIM-100TX/FX
!
CAUTION
Observe all static precautions while handling an EPIM.
!
CAUTION
When removing an EPIM, pull the module straight out to
prevent damage to the connector.
LNK
EPIM-100TX
EPIM 1
1511_09
SEHI Book Page 9 Wednesday, May 15, 1996 10:42 AM