Filter
Top Products
Management Terminal Setup
SEHI100TX User’s Guide 7-5
Management Terminal Setup Parameters
Table 7-2 lists the setup parameters for the local management terminal. If
the terminal is a Digital Equipment Corporation VT320 terminal, press F3
to access the Setup Directory. If the local management terminal uses
terminal emulation of the VT320, refer to the equipment user manual for
setup procedures.
Table 7-2 Terminal Setup Parameters
Menu Function Selection
Display Setup:
Columns 80 Columns
Controls Interpret Controls
Auto Wrap No Auto Wrap
Test Cursor Cursor
General Setup:
Mode 7 Bit Control
Cursor Keys Normal Cursor Keys
Communications
Setup:
Transmit Transmit = 9600
Receive Receive = Transmit
XOFF any option
Bits, Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit
Local Echo No Local Echo
Port
DEC-423,
Data Leads Only
Transmit any option
Auto Answerback No Auto Answerback
Keyboard Setup:
Auto Repeat any option
Keyclick any option
Margin Bell Margin Bell
Warning Bell Warning Bell
Auto Answerback No Auto Answerback
SEHI Book Page 5 Wednesday, May 15, 1996 10:42 AM