Filter
Top Products
Chapter 7: Local Management
7-20 SEHI100TX User’s Guide
7.8.6 Stepping Through OIDs
Use the following steps to STEP through OIDs (the user can step through
only after a GETNEXT):
1. Highlight STEP, using the arrow keys, then press ENTER. “Specify
OID” appears.
2. Enter the OID (only the suffix is necessary) and press ENTER. The
Tools screen will begin to scroll one OID at a time, through all of the
sublayers of the MIB available for that OID.
7.8.7 Cycling Through OIDs
Use the following steps to CYCLE through an OID:
1. Use the arrow keys to Highlight CYCLES, then press ENTER.
2. Enter the number of cycles desired to occur after “ENTER CYCLE
COUNT:”, then press ENTER.
3. Enter how many seconds delay desired between get next requests after
“ENTER CYCLE DELAY (secs):”, then press ENTER.
7.8.8 Exiting the SNMP Tools Screen
To exit the SNMP Tools Screen:
1. Use the arrow keys to highlight the RETURN command.
2. Press ENTER. The Feature Selection screen appears.
SEHI Book Page 20 Wednesday, May 15, 1996 10:42 AM