Filter
Top Products
Chapter 7: Local Management
7-10 SEHI100TX User’s Guide
6. To exit the screen, press the appropriate Function key or use the arrow
keys to highlight the RETURN command.
7. Press ENTER. The Feature Selection screen appears.
7.6 THE CONFIGURATION SCREEN
To access the Configuration screen from the Feature Selection screen, use
the arrow keys to highlight the IP Address Assignment option, then
press ENTER or F7. The screen shown in Figure 7-5 appears.
Figure 7-5 Configuration Screen
Assign the IP Address, Subnet Mask, and Default Gateway through the
SEHI Configuration screen. Use the Port Enable Override option to
enable all device ports in the stack. This option overrides the Port Disable
setting in the Statistics screen.
The following sections explain each field on the Configuration screen and
instructions on how to change them.
NOTE
The first time a user attempts to exit the screen without saving
the changes, a “NOT SAVED?” message is displayed. The
edits are lost if the user proceeds to exit without saving the
changes.
Cabletron SEHI Revision X.XX.XX
CONFIGURATION
SEHI LOCAL MANAGEMENT
SAVE COMMUNITY NAMES TRAP TABLE SNMP TOOLS RETURN
F6 F7 F8 F9
I/F IP Address SubNET Mask MAC Address
1 000.000.000.000 000.000.000.000 00-00-1d-05-dc-36
Default Gateway: 0.0.0.0
Serial Port 1 Application: CONSOLE Baud Rate: 9600 --ACTIVE-
-
Port Enable Override: OVERRIDE DISABLED
1490_24
SEHI Book Page 10 Wednesday, May 15, 1996 10:42 AM