Filter
Top Products
5-14
Hardware Maintenance Procedures
CAUTION Take care to properly align the SCP in the card
guides in the following step.
4. Insert the new SCP into the switch fabric by sliding it into the card
guides.
5. Push firmly to seat the SCP so that its faceplate is flush with the
front panel of the switch board.
6. Re-tighten the captive fasteners with a straight screwdriver to
ensure the SCP is secure.
Once the SCP has been installed and the system reboots, the PVCs will be re-
established provided that none of the network modules were replaced after
the SCP was removed and provided that all of these steps have been per-
formed properly.