Filter
Top Products
6-10
Software Upgrade Instructions
Before any of the above changes can take effect, inetd must re-read the config-
uration file.
NOTE: If you need to set up a tftpboot server, as
described in Section 6.5.4, the following pro-
cess is not necessary at this time. Instead,
make inetd re-read its configuration file after
setting up your server.
Determine the process number of inetd by entering the following:
host: ps -aux | grep inetd
Something similar to the following will be displayed:
root 216 0.0 0.0 48 0 ? IW Jan 27 0:14 inetd
where 216 represents the process number of inetd.
Now that you know the process number, enter the following command line to
make inetd re-read its configuration file:
host: kill -HUP 216
6.4.3 Adding an Entry for Your Switch in the bootptab File
On the workstation that is the bootp server, add the following lines to
/etc/bootptab:
NOTE: The lines given here are an example. See the
descriptions that follow for an explanation of
the values that you need to enter on your
SCP.
myswitch:\
:ht=ether:\
:ha=002048200097:\
:sm=255.255.255.0:\
:bf=upgrade-file: