Filter
Top Products
Installing the STHI
Page 3-4
Figure 3-4. Installing the Wall-Mounting Brackets
2. Select a wall location for the STHI within 7 feet of a power outlet.
Potential SHOCK HAZARD: Select a wall location where
pilot holes for screws will not intersect with electrical wiring
in the wall.
3. Get a pencil and refer to Figure 3-5. With the wall-mounting brackets
attached to the STHI, position the STHI against the wall where it will
be permanently mounted, with the network ports facing down, and
mark the screw holes’ positions on the wall.
4. Set the STHI aside and carefully drill four 1/4” pilot holes for the
screw anchors, one at each mark made in step 3.
5. Install the screw anchors. If installing on a hollow wall, use the
provided Molly bolt anchors (pictured in collapsed form as “Hollow
Wall Anchor” in Figure 3-5): insert the anchor into the hole, tighten the
screw to collapse the anchor’s bracing arms, and remove the screw. If
installing on a solid wall, a different type of anchor will be required.
6. Position the STHI on the wall, aligning the screw holes over the
anchors, and fasten the STHI to the anchors with the four anchor
screws. Tighten the screws.
WARNING