Filter
Top Products
HSIM-W85 User’s Guide 2-1
CHAPTER 2
INSTALLATION
To install the HSIM-W85 the following items are required:
• Antistatic wrist strap (shipped with the HSIM-W85)
• Phillips screwdriver
2.1 UNPACKING THE HSIM-W85
Unpack the HSIM-W85 as follows:
1. Remove the HSIM-W85 from the shipping box.
2. Leave the module in its antistatic bag until you are ready to install it.
3. Attach the antistatic wrist strap (refer to the instructions on the
antistatic wrist strap package for proper use).
4. After removing the module from its antistatic bag, visually inspect the
device. If you notice any signs of damage, contact Cabletron Systems
immediately. Refer to Section 1.8 for instructions. Save the antistatic
bag in the event the module must be reshipped or relocated.
NOTE
Before attempting to use the HSIM-W85 you should be familiar
with the
IEEE 802.3 Specifications,
and T1 Networking.
!
CAUTION
The HSIM-W85 and the host platform are sensitive to static
discharges. Use an antistatic strap and observe all static
precautions during this procedure. Failure to do so could result
in damage to the HSIM-W85 or host platform.